
CAT NO. XJP60D
I/O Probe Monitoring Modules
MODEL XJP60D OVERVIEW
The Monitor has three status LED’s: Power, Rx/Tx and Alarm. The
Monitor has either 6 NTC probes or 6 4
...
20mA or 0/10V inputs and
3 Digital inputs. Alarm Setpoints with delays can be assigned to each
probe. It shall have a RS485 Connection.
MOUNTING
The product is 4DIN RAIL or wall mounted in a DinBox and shall have
IP65 protection from the front.
SENSORS
The product has up to 6 NTC Thermistor temperature probes, range
of
–
58/230°F, which can be extended up to 300ft. using standard
thermostat wire or 6 4
...
20mA or 0/10V inputs.
POWER
The product shall be powered by 24Vac and use a class 2cULus
transformer.
INPUTS
The control shall have 3 Digital inputs (open/closed circuit) that is
typically used with a magnetic door switch to indicate door openings
or a CT to record events such as defrost or fan failure.
OUTPUTS
The XJP60D has a RS485 Serial communications output to be
connected to a XWEB System.
COMMUNICATIONS
The Control shall have a RS485 Serial Port.The two way com-
munication protocol shall be MOD-BUS-RTU. The Module shall
have a settable serial addr
ess fr
om 1 to 24
7. MOD-BUS Comments,
Registers and Hex Codes are free and open, and are available on
request.
PROGRAMMING
The control is pre-programmed and pre-addressed for NTC temperature
recording applications. The temperature shall be recorded every
15 minutes. There shall be 2 levels of control parameters that are
password protected. A Hot Key flash memory device can upload
or download a pr
ogram to the unit. The program shall remain in
internal memory without power.
WEISS INSTR
UMENTS,
INC., 905 WAVERLY AVE., HOLTSVILLE, NEW YORK 11742 • 631.207.1200 • FAX: 631.207.0900
•
www
.weissinstruments.com
SPECIFICA
TIONS SUBJECT
TO CHANGE WITHOUT NOTICE
W
ARRANTY
ONE YEAR
Kommentare zu diesen Handbüchern